This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nrf51 smart beacon kit jtag programming

Hi,

I have just received my smart beacon kit (nRF51822 based), I have wired up my JLink programmer according to devzone.nordicsemi.com/.../

However I am having trouble detecting the beacon kit on nRFgo Studio. nRFgo studio keeps saying that no device detected.

Normally, after inserting the battery, the beacon's LED will start flashing. If I plug in the programmer afterwards, nRFgo studio doesn't detect the device.

After a few tries, I managed to find 1 particular condition that allows the nRFgo studio to detect the device, which is connecting the JTAG programmer first, and then put the battery in. Now the LED doesnt turn on at all. When I click the refresh button for the first time on nRFgo studio, the device is detected, with the correct IDs, SD version etc. Then the LED would start flashing. However, if I click the refresh button again, the device is no longer detected.

I suspect that once the device is booted and the application is running, it somehow cuts out the JTAG interface.

Could anyone share some light in this issue? Cheers.

Warm regards, Mike

Parents
  • Yes, I'm using pin 1,2,4,5. As for the connection, I just soldered wires directly to the pad, and directly into the 20in connector on JTAG programmer. Pull up for SWDIO, no pull for SWCLK.

    I cannot erase the chip unfortunately, after it is detected the first time, any button I press: refresh, erase, read etc... Will result in device not found.

Reply
  • Yes, I'm using pin 1,2,4,5. As for the connection, I just soldered wires directly to the pad, and directly into the 20in connector on JTAG programmer. Pull up for SWDIO, no pull for SWCLK.

    I cannot erase the chip unfortunately, after it is detected the first time, any button I press: refresh, erase, read etc... Will result in device not found.

Children
No Data
Related