HOW TO SHOW DEVICETREE TAB UNDER ACTIONS WINDOW?

[gianmarcod]

Hi everyone,

I am currently attending the nRF Connect Fundamental Course.

As you can see from the picture below (taken from the Course material), there must be the chance to see the device tree directly from the Actions window.

But as you can see, I do not have the DeviceTree tab under my Actions window.

I remember that I didn't have the Guiconfig tab as well, I learned how to include it during the lectures. But I couldn't figure out how to inlcude the DeviceTree tab.

Does anyone know how to do it?

Thanks in advance!

Gianmarco

[Marte Myrvold]

Hi Gianmarco,

Devicetree is not under the Actions tab, but it is its own tab:

If this tab is not visible then you can enable it by clicking on the three dots next to "NRF CONNECT" and enabling "Devicetree":

Best regards,

Marte

[gianmarcod]

Hi Marte,

Thanks for your quick response.

If I do not have the DeviceTree listed in the list, do you have any other ideas about how to enable it?

Thanks,

Gianmarco

[Marte Myrvold]

Hi Gianmarco,

Can you check that you have the Devicetree extension installed? If you go to the extensions tab on the side in VS Code you should see an extension called "nRF DeviceTree". If the extensions is not there then you can either search for it in Marketplace in VS Code or install it from here: https://marketplace.visualstudio.com/items?itemName=nordic-semiconductor.nrf-devicetree

Best regards,

Marte

[gianmarcod]

I was missing the extension. Thank you very much for your support.

Regards,

Gianmarco