nrf5340-DK hci_uart gpio connection mapping

[Achyuth]

Hi 

i am working on the nrf5340_dk for making as a controller through the hci_uart build.

can i know the gpio connection mapping on the board?

regards,

Achyuth

[Raoul]

Hi Achyuth,

Have you been able to make progress?

I realise that I have misunderstood your original question. You were probably asking about the specific pin assignment for the UART connection which relays the HCI interface. In that case, the answer is that you can decide that yourself by creating a devicetree overlay file. As long as you don't select the same pins as are used for logging/printing via the interface MCU, it should be fine. Please see this case for more information - but note that NCS 2.0.0 introduced Pin Control, so there will be some differences.

Best regards,

Raoul