Error when attempting to enable radio interrupt

[avers]

Hello guys, i'm attempting to record the radio_end event, and i tried to enable it with the following code:

const uint32_t mask = NRF_RADIO_INT_END_MASK;
nrf_radio_int_enable(mask);
bool interupt_enabled = nrf_radio_int_enable_check(NRF_RADIO_INT_END_MASK);
NRF_LOG_INFO("Intterupt(%d) enabled : %d",NRF_RADIO_INT_END_MASK, interupt_enabled);

However, the second line constantly crashes the chip.

In my speculation this is because i'm using the BLE softdevice, however, i found an older post mentioning that i first have to enable the interrupts somehow, is this still correct?

[Jørgen Holmefjord]

Hi,

If you are using the Softdevice and this has been enabled, you should not access the RADIO peripheral directly, unless you are in a radio timeslot. The Softdevice will block/restrict access to Hardware peripherals used by the Softdevice when it is enabled, accessing the peripherals will cause the Softdevice to assert.

The Softdevice will handle anything related to radio interrupt by itself, this is not something you need to configure manually in your application.

Best regards,
Jørgen