nrf51822 blinky with softdevice 0V on LED pins

[Vrabec]

Hi,

I try blinky with softdevice example and reconfigure it to support nRF51822AA. I can program my custom board, I can debug as well, but led is not blinking. I have connected currently only VCC, GND, SWDIO, SWDCLK and some ports to LEDs. I measure voltage of all PINs and it seems, nrf got enough power (3.27V). When I meassure pins connected to LEDs and there is 0V. With uVision GPIO window I can clearly see, pins are set to output and HIGH.

Can anybody help me? I will provide additional info, if it's necessary.

[Inspectron]

Did you defined the LEDs as output?

[Vrabec]

Yes, I did. Meanwhile I found also reason. In my board definition, LED pins was mapped to port which are not broken up. I changed this and everything working like a charm.

[Vrabec]

I found reason & solution. My LED mappings leads to port which are not broken up in my custom board. After fixing this, everything works well.