This previous case is an example of what i am trying to do.Reconfifure the radio parameters.
nRF52840 BLE/NFC compliance testing, How to Change Channel & which tool to use ?
Using example code does not work for me. the DUT has other aspects that need to be EMC compliant, firmware is required to drive these aspects. I also have no access to a serial or UART port on the DUT. So, i cannot simply load example code in (which doesn't complile and run properly anyway!). Additionaly, i dont see this being a valid test platform, even if i did have uart communications on my board. This is not representative of the devices normal operation, so just loading example code in for compliance testing does not seem legitimate?
Having dug through this example i am trying to use some of the functions that the example uses, to make basic adjustments to the physical characteristics of the radio output.
This is for pre-compliance testing. Thus relatively informal.
As per the attached thread. I am starting by trying to simply adjust the channel on which the device transmits. - nothing complex. Just this to start with.
I am trying to do this with the following function. Currently this is run while the device is advertising (possibly part of my problem?) and throws up errors. Beleive the error is softdevice invalid memory access, what must i do to the ble to be able to adjust channel number during operation?
radio_channel_set(NRF_RADIO_MODE_BLE_1MBIT,0);
I can find no obvious set of rules for this function and next to no useful/meaningful documentation for it. But it clearly pretains to what i need to do.
Note: I do not want to pursue some highly abstracted solution. I am on a tight deadline and have tried including the radio_cmd file & other solutions that do not directly call the nrf_radio functions, but i faced endless dependancy issues that i simply dont have time to solve). I just need this function to work when called directly.
