This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Programm Sniffer Firmware to nRF51822

Dear Developer Zone

I have searched now a lot in the Internet, mostly the say it's possible to reprogramm the Firmware of the nRF51822. I have such a chip and a JLink Debugger. Is it possible to download the sniffer .hex File via the JLink Debugger in the nRF51822? Which Software can do this? Are there any tutorials or how to's?

Thanks in Advance for Answers!

Parents Reply
  • Thanks for your answers. Now I just need to know where to connect which programming pin. As I have seen in the MDBT40 Datasheet, the Reset and SWDIO are connected together? Have you remapped the Reset Pin on your board? Do I Need to connect the TDI and TDO Pins?

    Thanks a Lot in Advance!

Children
No Data
Related