nRF52833dk only working when flash via nRFgo Studio

[binhla]

Dears, 

Currently, when working with the nRF52833dk, I found some weird behavior.

I tried to run the blink example in nRF5_SDK_15.3.0_59ac345\examples\ble_peripheral\ble_app_blinky\pca10040\s132.

I flash it via diferrent way:

1. First SoftDevice via nRFgo Studio, then Application via nRFgo Studio

2, First SoftDevice via nRFgo Studio, then Application via keil C

3, Flash the SoftDevice and the Appication via nRF connect Programmer v3.0.4

 

Note that I already erase all the chip before every tries.

Only when I flash the first way - using nRFgo Studio for both SoftDevice and Application - the soc run.

Other ways, the soc cannot run.

By reading back the SOC, I found no diffrent for both three ways of flashing.

I attached the Application hex file nrf52832_xxaa.hex and the SoftDevice file s132_nrf52_6.1.1_softdevice.hex

2625.nrf52832_xxaa.hex

1220.s132_nrf52_6.1.1_softdevice.hex

My questions are:

1. What is wrong with the 2nd and 3rd way of flashing?

2. How to solve it?

Please awswer, I am trying to run the /dfu/secure_bootloader but it cannot be flash via nRFgo Studio. And when I test with the blink example. This issue happen.

Best regards.

[Sigurd]

Hi,

I tested your .hex files here, and it works fine when I flash using nRF Connect programmer app. I can see the device advertise as "Nordic_Blinky".

1) Could you try to do an "Erase all", "Erase & Write", and then click "Reset" in the programmer app?

2) What version of the nRF52832-DK are you using?

[binhla]

Hi, 

Thank your for your prompt support.

Sigurd said:

2) What version of the nRF52832-DK are you using?

My DK version is V1.2.1

Sigurd said:

1) Could you try to do an "Erase all", "Erase & Write", and then click "Reset" in the programmer app?

Yes, I tried and it worked. 

Many thanks.

Best regards.