nrf Connect SDK Fundamentals Lesson 5 Excercise 1 doesn't work with thingy:53 and nRF5340-DK

[SaSu]

Hello

I worked this example with nRF52840-DK kit it works very well. But, when i use thingy:53 with nRF5340-DK, I am not getting any ouput in puTTY screen. Even any example is not working with these 2 boards as i am using nRF52840-DK since start of the nRF connect SDK Fundamentals course it works evrything fine. But with thingy:53 with nRF5340-DK even i cannot see the simple hello world output. But the LED still blinks.

What would be the problem?

Regards

[Priyanka]

Hi,

Hvae you checked the Programming THingy53 guide?

Also, please take a look at the Developing for THingy:53 and Getting started with Thingy:53

Best Regards,

Priyanka

[SaSu]

Hello,

Thanks for the reply,

So, I used the same program which is in Lesson-5(Exercise-1) solution for thingy too. Actually they did not mention anything in that lesson that if i use thingy i should follow different rules. Do I have to do any extra apart from the things mentioned in that exercise?

[Priyanka]

Hi,

I guess you are talking about the Exercise in DevAcademy. Have you verified the following mentioned at the end?

-Priyanka

[SaSu]

Hello,

Yeah, I have seen that, basically that is led lights how it shows, eg: for nf52840-DK the led lights is red which doesn't change when we press number in PuTTY screen and for thingy it changes colors as far as i unerstood. Can you try that example with thingy:53 and nRF5340-DK and tell me its working well for you and shows some ouput in PuTTY screen.?

[Priyanka]

I am trying to reproduce it. Are you able to flash it onto the Thingy? And do you get the LED to turn on after flashing? Or does it blink?

-Priyanka