• State Not Answered
  • Locked Locked
  • Replies 9 replies
  • Subscribers 63 subscribers
  • Views 4423 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 109333
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Failure to loadfile binary to my PCB w/ nRF51822 using nRF51 DK Debug Out

i_am_trying

I have built a PCB that uses the nRF51822 . I am failing to load the binary onto the chip via the nRF51 DK. I can:

connect to the nRF51822 on my mac using the JLinkExe.

execute the erase command in JLink I have a small binary called LED_TEST.hex that I attempt to load. No matter how many times I run loadfile, I get the message:

Downloading file [LED_TEST.hex]...Info: J-Link: Flash download: Restarting flash programming due to program error (possibly skipped erasure of half-way erased sector). Info: J-Link: Flash download: Skip optimizations disabled for second try. Error while programming flash: Programming failed.

I'm looking for ideas on how to best debug this. I have a file that I logged the SWD traffic into. I am new to SWD traffic, and there are A LOT of records...so i'm not sure where would be the best place to focus within the SWD traffic in order to tip me off why this is happening. Here is the log file: LBL_SWD_loadfile.txt

Parents
  • 0

    Looking at "good" SWD traffic versus "bad" traffic, one thing that pops out are writes to the DebugPort return a FAULT from the external nRF51822. If this is the reason, perhaps the nRF51 DK (host) cannot write to Flash. Now i need to figure out how to test this by sending a write to flash within the JLINK command tool.

Reply
  • 0

    Looking at "good" SWD traffic versus "bad" traffic, one thing that pops out are writes to the DebugPort return a FAULT from the external nRF51822. If this is the reason, perhaps the nRF51 DK (host) cannot write to Flash. Now i need to figure out how to test this by sending a write to flash within the JLINK command tool.

Children
No Data
Related