Disable UART1 of nrf52840 DK and re-configure pins as GPIOs at runtime

[siwa]

Hi,

we are currently using NCS 2.0.2 on nRF52840.

Is it possible to disable uart1 via pinctrl or another library during runtime and re-configure the rx/tx as gpios?

We need to set the two pins in low-state to allow another module enter its sleep mode while the nrf stays awake.

Regards,

Simon

[Hung Bui]

Hi Simon, 
Your question is similar to this question here.

Our answer for now is that it's not possible. You can have a look here: https://developer.nordicsemi.com/nRF_Connect_SDK/doc/latest/zephyr/hardware/pinctrl/index.html#dynamic-pin-control

Dynamic pin control should only be used on devices that have not been initialized. Changing pin configurations while a device is operating may lead to unexpected behavior. Since Zephyr does not support device de-initialization yet, this functionality should only be used during early boot stages.

[siwa]

Hi Hung,

Thanks for your quick reply.

Then I have a further question. Is it possible to set them (tx/rx) low during sleep mode?