nrf5340 is unable to trigger rpmsg(ipc) transfer

[Dumam]

Hi,

I have quite demanding SPI device which should send its data over BLE.
Thanks to throughput example i was able to achieve maximum transfer speeds for synthetic tests (without SPI).
Sadly after adding real data input, I noticed that no transfer is executed until I finish my commands. 

Thanks to SystemView I was able to narrow this problem to one part of configuration -> rpmsg.

Colors:

Green -> spi thread
Yellow -> bt_hci thread
Orange -> ble host TX
Red (small squere in top) - IRQ 58 from probably ipc, but i wasnt able to find it in manual (not listed)
Blue - probably openAmp mailing work queue thread
purple - systemwork queue

SystemView Data Log
4010.BleProblem.dat

Here is repo with configs etc.
https://github.com/DuMaM/bitly_nrf5x

[Edvin]

Hello,

I am not sure I understand the question? What are you seeing, and how do you expect it to work?

I noticed that no transfer is executed until I finish my commands. 

What sort of commands are you talking about here?

BR,
Edvin

[Edvin]

Perhaps I was a bit short, but I suspect that you expect to be able to create some sort of stream to send one byte at the time. That is not the case, according to the Bluetooth specification. You need to construct complete packets, and send them to the receiving device.

BR,
Edvin