Hi Everybody,
I need help in writing a little software on NRF52805 which will active the transmitter with parameters:
1) Frequency : 2402Mhz only. (and i will later make changes for other versions for 2440Mhz and for 2480Mhz)
2) Duty cycle ~ 100%
3) I don't care about the payload...
When starting the unit is should start to transmit in this specific frequency forever...
I saw the DTM example but it's a little bit complicated and over kill for me, also i don't got uart on my custom board.....
Can anyone help here in letting me know what to change in the DTM or anybody got a ready made software for this task ?!
Bless you !
