nRF Connect SDK

[RADHIKA RAINA]

While interfacing LIS2DH Sensor with my nRF 52832 Board, I am getting the data in x, y and z axis. But the values of x,y and z axis remains same in each reading which is not correct. How to get the different values of x, y and z axis in each reading?

[Karl Ylvisaker]

Hello,

Please elaborate. How have you set up / configured the sensor? How are you communicating with it, which interface are you using?
What command do you run when you are reading the values?

From your description it sounds like you have not triggered a sampling inbetween your readings, and so you are just reading the old values again each time.

Best regards,
Karl