Hello,
NCS2.0.2, vscode, nRF5340
C:\ncs\v2.0.2\zephyr\samples\boards\nrf\system_off
P1.00 will take 96uA in sleep mode,
change another pin will take 1uA.
why P1.00 can't using for wakeup?
Best regards
Hello,
NCS2.0.2, vscode, nRF5340
C:\ncs\v2.0.2\zephyr\samples\boards\nrf\system_off
P1.00 will take 96uA in sleep mode,
change another pin will take 1uA.
why P1.00 can't using for wakeup?
Best regards
devzone.nordicsemi.com/.../p1-00-with-config_bt-in-ncs2-0 had a similar problem, P1.00 was by default configured as a UART pin; see if that helps you sort it out?
Hi
thanks for reply,
i konw it , i do it and solve P1.00 for button and P0.13 for I2S no sound out as follow:
CONFIG_SERIAL=n
void go_system_off(void)
{
printk("%s system off \n", CONFIG_BOARD); // P1.00 take 96+uA
nrf_gpio_cfg_input(32,NRF_GPIO_PIN_PULLUP);
nrf_gpio_cfg_sense_set(32,NRF_GPIO_PIN_SENSE_LOW);
const struct pm_state_info si = {PM_STATE_SOFT_OFF, 0, 0};
pm_state_force(0, &si);//1.9.99+
k_msleep(100);
}