Failure to build an application for the sample: Bluetooth: Peripheral HR for my board: nRF5340dk_nrf5340

[Jacek Majda]

I tried unsuccessfully to build an application for the sample: Bluetooth: Perpheral HR - that could be found under samples/bluetooth/peripheral_HR , in the Zephyr Tree - using the build target: nrf5340dk_nrf5340_cpuapp_ns, for my board: nRF5340dk_nrf5340.  I am using nRF Connect SDK v2.2.0.

The build process was terminared with the message:

"Configuring incomplete, errors occurred!  FATAL ERROR: command exited with status 1"

I attach a screenshot of the page with all eror messages that showed up during the build process.

How can this problem be overcome?

Regards,

JM

Error messages - 11 January 2023.docx

[Kazi Afroza Sultana]

Hello,

Did you use toolchain manager during installation of NCS v2.2.0? You may try to reinstall this.

Thanks.

Best Regards,

Kazi Afroza Sultana

[Jacek Majda]

Hello,

As advised, I have reinstalled the NCS v2.2.0 and I tried to build an application for the sample: Bluetooth: Peripheral HR , that can be found under: samples/bluetooth/peripheral_HR , in the Zephyr Tree , using the following build target: nrf5340dk_nrf5340_cpuapp_ns , for my board: nrf5340dk_nrf5340.

However, the build process was terminated again with the following error messages: 

"Configuring incomplete, errors occurred! FATAL ERROR: command exited with status 1."

I attach a screenshot of the page with all error messages that showed up during the build process.

How can this problem be overcome?

Am I using the correct build target for this sample?

Should I use one of the following build targets for this sample: nrf5340dk_nrf5340_cpuapp or nrf5340dk_nrf5340_cpunet or yet another build target for this sample?

Regards,

JM

Error Messages 13 January 2023.docx

[Kazi Afroza Sultana]

Peripheral_HR is built for nrf5340dk_nrf5340_cpuapp_ns or nrf5340dk_nrf5340_cpuapp. 

So, your build target is ok. You also get the same error if you try the nrf5340dk_nrf5340_cpuapp as build target?  

[Jacek Majda]

Yes, I am getting the same errors when I try the nrf5340dk_nrf5340_cpuapp , as build target.

I then tried to build a simple sample: "Blinky" for the build target nrf5340dk_nrf5340_cpuapps_ns  , but again unsuccessfully! The error messages that showed up during the build process of the sample" "Blinky" are shown on the attached screenshot.

As I said earlier, I did reinstall NCS v2.2.0 as advised by you, but how can I know if all required files were downloaded and installed successfully on my PC,  as a result of my reinstallation of SDK v2.2.0 ?

Error messages 16-January-2023.docx

[Kazi Afroza Sultana]

Hello,

Have you tried to run the sample using west command from command line tool?