Hello,
I want to switch off the power supply to my LSM6DSO IMU between measurements. The measurements only take place once a minute. If I operate it permanently with voltage, it would consume about 200uA. To save this, I switched off the voltage. Unfortunately this does not work, I no longer get any values back when I query the sensor. I tried it with different delays between switching on and measuring, but 0 values are always displayed. If I constantly power the IMU, everything works.
You can watch it briefly in a video. www.youtube.com/watch
nrf connect sdk 2.1.2
What do I have to change to make this work? or how can I initialize the lsm6dso manually?
Best regards, Jonas
gpio_pin_set(gpio_dev, VDD_PIN_IMU, 1); k_sleep(K_MSEC(10)); remap_pins_imu(); pm_device_action_run(imu_dev,PM_DEVICE_ACTION_TURN_ON); get_rotation(imu_dev); pm_device_action_run(imu_dev,PM_DEVICE_ACTION_TURN_OFF); k_sleep(K_MSEC(10)); // gpio_pin_set(gpio_dev, VDD_PIN_IMU, 0);dynamic_pinctrl_evaluation.zip