In my design I need the RX to be standalone , I.E. no controller attached to it , does the programming STORE in the Chip ? If I set it up as a RX and set a specific Ch. Freq. for that RX will all this store on power down ( I searched the manual but it was not clear ) so when it is powered up again nothing needs to be reset?
also how fast do the channels change ? I want to set each RX ( up to 48 of them ) to an individual unique Channel then select that ch via GUI interface that I have . via USB and a servo controller . I am sending RC servo signals over the links ( just 0-5vdc pulses that vary ) each ch. controls a different motor.
I know you can use addresses for each RX , and I am looking into that as well , any basic info on addressing would be helpful ,. total Newbie here so be nice !@