NRF52810 Power Issue (SPI )

[Vijil Jose]

I do have different issue with Nrf52810. I am trying to build a wearable device with NRF52810 and LSM6DSMTR.
I am measuring the current towards the NRF52810 using a series resistor (100E).

Rectangle part is SPI Communication (NrF Delay) in the graph

Whenever I send an SPI command, I can see there is a triangle based current consumption (Not sure what it is ). 
You can see the image without SPI as well.

I am using SES V5.62 (SDK 7.2.0) 

[Stian Røed Hafskjold]

Hi, can you try with a lower value series resistor, and check if you see the same thing? 100 Ohm is quite large, and you will get a significant voltage drop when the current increases. Maybe try with 10Ohm maximum.

Is the LSM6DSMTR powered from the same power source? I.e. does it have the same voltage level? Are you able to measure the voltage on the MISO pin (and any other input pins you might have) and see if it is at a stable voltage during the triangular shaped period, and not floating up and down?

[Vijil Jose]

Hi,
I have tried with lower resistance also. results are pretty same. I am using a 3V coin cell Battery

LSM6DSMTR also using the same 3V supply. it is having the same voltage level

MISO I will check and update you

[Vijil Jose]

This is an issue with IMU sensor, It is taking power through SPI lines. I moved teh Question to STM community 

https://community.st.com/s/question/0D53W000025d3DZSAY/lsm6dsmtr-taking-more-power-on-vddio-pin


You can close the ticket from here

[Vijil Jose]

I have checked all the ways. Its not an issue associated with the sensor.  
I also connected a AS6212 temperature sensor to the same chip using I2C lines. 

Noticed same kind of issue there also. But When  I commented //twi_init(); &  //twi_deinit(); from teh call function issue resolved.
So I hardly believe this is something with the SPI lines.

float AS6212_read_temp(void)
{

  float temperature_c = 0.0;
  bool singleSt = 0;
 
  //twi_init();

  nrf_drv_twi_enable(&m_twi);

  triggerSingleShotConversion();// enabling sleep mode

  nrf_delay_ms(AS6212_CONVERSION_TIME); //conversion ongoing

  for(char i=0; i<10; i++)
  {
    singleSt = getSingleShotStatus(); 
    if(!singleSt) {break;}
    else
    {
     NRF_LOG_INFO("AS6212 Conversion Not completed"); 
     nrf_delay_ms(5);
    }
  }

  temperature_c = readTempC();


  nrf_drv_twi_disable(&m_twi);  
  //twi_deinit();

  return temperature_c;
}

[Stian Røed Hafskjold]

Do you have the schematics of the board? It sounds to me like some of the GPIOs are incorrectly configured. Have you enabled pullup reistors on the TWI lines?