Hi,
we have nrf51822 custom hardware.
we are flashing application through j-link.
but after every flashing , i need to do switch off and on the device.
then only i am getting advertisement.
Here my code size is 27KB.
But actually my device has battery. Every flashing i cant remove the battery and put it.
Is it because of code size or j-link.
Kindly suggest me or give me some hints.
Regards Balaji
I'd recommend you to verify that "Reset and run" is checked in the Keil project settings, as shown in the attached screenshot. If not, the device will not be reset after downloading a new application, and instead just hang somewhere.
However, keep in mind that when not power-toggling after a download, the debug interface will stay enabled, giving quite high current consumption. Take a look at this question for details.
