？？Operating the nrf52833 development board keys always reset when burning the openthread client program

[caidehen]

• The specific error information is shown in the figure above

[Jørgen Holmefjord]

Hi,

Which exact sample are you running?

Which nRF Connect SDK version are you building from?

Have you made any modifications to the sample before building?

Can you describe the exact steps you followed to make the board reset?

Did you erase the full board before programming the new application?

Best regards,
Jørgen

[caidehen]

I burned the openthread client program on the nrf52833dk_nrf52833 development board. Before burning, I had erased all the flash. After burning the program, I began to press the button repeatedly, and then the program reset the serial port error as shown in the figure above