I have created customized services, but not able to connect peripheral using Android Phone

[SHubham]

I have created customized services according to nAN36 Document. Everything is fine and it is advertising perfectly.

But issue is I don't have any Android APP for same services. But I tried to connect it using my Android phone without, to check ,whether it able to bond with Phone or not.

On Android Device I followed these steps :

1. Settings -> Bluetooth -> Scan -> MyDeviceName.

But whenever I tried to connect with MyDeviceName, the phone shows an error could not connect. Along with this the LED blinking on nRF51-DK board won't stop blinking. Which is process of it keeps on advertising.

Can you please suggest me the issues and solutions.

[Petter Myhre]

You should test with Master Control Panel for PC or nRF Master Control Panel for Android.

[SHubham]

I used nRF Master control on Android Device to connect with peripheral device.

On the screen of nRF Master Control Panel, I got following messages

Connected to Device FFxxxxxxxxx..... gatt.discoverServices() [callback] connection state changed with status: 133 and New state : 0 (DISCONNECTED) Error (0x85): GATT ERROR

I hope you may got this.

And at the time of connecting with phone using this nRF Master control panel APP.. On my nRF51-DK board all four LED start glowing at the same time. This glowing of all four LED at the same time signify the peripheral entered into some deadlock condition (hanged).