Establishing communication between EVM430FR6043 and nRF52832

[Akshat Lalit]

Hello, I want to configure the nRF52832 such that if I send a command 'start' from the nRF connect app to UART, I can toggle an LED on EVM430FR6043 and configure one of the EVM's pin as input to the data which is being sent from EVM to nRF . How can I do the change in the UART code of nRF ?

[helsing]

Hello Akshat, I will look into this and get back to you.

[Akshat Lalit]

Sure , thankyou

[Akshat Lalit]

Sir I had one more query regarding this is that does nRF52832 consists of other pins which can be used for UART communication other than 5,6,7,8?  

Also when are these 23 and 24 pins used?

[helsing]

Akshat Lalit said:

does nRF52832 consists of other pins which can be used for UART communication other than 5,6,7,8?

Yes, assuming you are referring to the DK, please see the section connector interface for nRF52832 DK to see which pins have default settings. The rest of the pins may be used. In addition you can also free up the pins used for buttons and LEDs by configuring their solder bridges. P0.21 is used for Reset.

Akshat Lalit said:

Also when are these 23 and 24 pins used?

Sorry, I am not exactly sure what you are asking. What would you like to do?