SDHC SPI Send Command

[dario.sortino]

Hello.

I have a custom board featuring nRF5340. I placed a microSD card reader in my board connected to SPI. I followed the fatfs zephyr example, but I'm struggling in mounting the disk.

I can correctly see the block count, sector size and capacity of the microSD, but as soon as I try to run fs_mount(&mp), the board resets.

When debugging, I saw that the board resets as it tries to run the function sdhc_spi_send_cmd

I don't know where the problem can be, since as I said I can correctly see the capacity of the card (I'm using a Premium microSDHC 32gb card by Verbatim )

I already tried to format the card both with Windows10 and the program SDCardFormatter, but nothing changed.

My devicetree for the spi/sd device is 

&spi1 {
	compatible = "nordic,nrf-spim";
	status = "okay";
	cs-gpios = < &gpio0 7 GPIO_ACTIVE_LOW >;
	sck-pin = < 8 >;
	mosi-pin = < 9 >;
	miso-pin = < 10 >;
	sdhc0: sdhc@0 {
		compatible = "zephyr,sdhc-spi-slot";
		reg = <0>;
		status = "okay";
		label = "SDHC0";
		mmc {
			compatible = "zephyr,sdmmc-disk";
			status = "okay";
		};
		spi-max-frequency = <16000000>;
	};	
};

And my connector is the following

[Simonr]

Hi

By multicore, do you mean the multicore sample available here? If yes, do you see the same issue if you let CONFIG_BT enable the net core in the fat_fs sample?

Try to build with MCUBoot enabled instead of both cores, and see if that still works (MCUBoot enables the partition manager).

Best regards,

Simon

[dario.sortino]

I just tried to enable CONFIG_BT in the fat_fs sample and I see the same erroneous behaviour.

About MCUBoot, can you provide to me a reference on how to build with MCUBoot enabled?

[Simonr]

If you set CONFIG_BOOTLOADER_MCUBOOT=y in the prj.conf of you application, the mcuboot will get added as a child image and you will have a multi image build (the partition manager will also get enabled and used to partition the flash).

Best regards,

Simon