SDHC SPI Send Command

Question

Hello.

I have a custom board featuring nRF5340. I placed a microSD card reader in my board connected to SPI. I followed the fatfs zephyr example, but I'm struggling in mounting the disk.

I can correctly see the block count, sector size and capacity of the microSD, but as soon as I try to run fs_mount(&mp), the board resets.

When debugging, I saw that the board resets as it tries to run the function sdhc_spi_send_cmd

I don't know where the problem can be, since as I said I can correctly see the capacity of the card (I'm using a Premium microSDHC 32gb card by Verbatim )

I already tried to format the card both with Windows10 and the program SDCardFormatter, but nothing changed.

My devicetree for the spi/sd device is

Fullscreen

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
&spi1 {
    compatible = "nordic,nrf-spim";
    status = "okay";
    cs-gpios = < &gpio0 7 GPIO_ACTIVE_LOW >;
    sck-pin = < 8 >;
    mosi-pin = < 9 >;
    miso-pin = < 10 >;
    sdhc0: sdhc@0 {
        compatible = "zephyr,sdhc-spi-slot";
        reg = <0>;
        status = "okay";
        label = "SDHC0";
        mmc {
            compatible = "zephyr,sdmmc-disk";
            status = "okay";
        };
        spi-max-frequency = <16000000>;
    };  
};
XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX

&spi1 {
	compatible = "nordic,nrf-spim";
	status = "okay";
	cs-gpios = < &gpio0 7 GPIO_ACTIVE_LOW >;
	sck-pin = < 8 >;
	mosi-pin = < 9 >;
	miso-pin = < 10 >;
	sdhc0: sdhc@0 {
		compatible = "zephyr,sdhc-spi-slot";
		reg = <0>;
		status = "okay";
		label = "SDHC0";
		mmc {
			compatible = "zephyr,sdmmc-disk";
			status = "okay";
		};
		spi-max-frequency = <16000000>;
	};	
};

And my connector is the following