Turn on all 4 led using master and slave

[Jaydeep shah]

how to turn on all 4 led one by one pressing button from transmitter and receiver.

[Vidar Berg]

Please provide more details about your current setup and what you want to achieve. For instance, what SDK version you are using, what wireless protocol you intend to use, etc.

[Jaydeep shah]

I have two nRF52DK 52832 board. When I want turn on LED on board no.2 (RX) then have to I have to press button on board no.1(TX). if I press button in board no.1  then LED should be turn on no.1 LED  in board 2.  respectively same for LED 2,3,4.

currently i am using this program

TX :   C:\nrf_sdk\examples\ble_peripheral\ble_app_blinky\pca10040\s132\ses

 RX :  C:\nrf_sdk\examples\ble_peripheral\ble_app_blinky\pca10040\s132\ses

[Jaydeep shah]

i want to turn on LED by using Bluetooth protocol 

[Jaydeep shah]

currently I am using SEGGER embedded studio for ARM 7.10a

[Vidar Berg]

Ok, so everything is working as expected now, except you want to turn on all LEDs, not just LED 1? In that case, you can replace the calls to bsp_board_led_on(LEDBUTTON_LED); and bsp_board_led_off(LEDBUTTON_LED); with bsp_board_leds_on(); and bsp_board_leds_off(); respectively.

Note that if you do this, you can no longer use BSP_BOARD_LED_1 and BSP_BOARD_LED_0 to indicate connection and advertising status.