Hi,
Is it possible to connect a device over UART (ideally not over the USB port) to the thingy:53?
Thanks!
Hi,
Is it possible to connect a device over UART (ideally not over the USB port) to the thingy:53?
Thanks!
Hi.
1. I don't think there are any good way to solder a connection to the pins. As I wrote in the my first post the thingy is limited in terms of easy accessible GPIO pins.
2. You can either use Stemma/Qwiic/Grove to access the 4 pin JST connector
infocenter.nordicsemi.com/.../qwiic_stemma_grooveif.html
Regards
Runar
Hi Runar,
In the diagram you sent I don't see P0.04 & P0.05 listed on the expansion board.
Hi Avi
They are listed as EXP_BOARD_PIN1 and EXP_BOARD_PIN2. However if you look in the pin map they are also described as P0.04 and P0.05
Regards
Runar
Hi, OK I do see that, thanks. However I see them only listed as SDA & SCL, not UART Tx / Rx.
I appreciate your help so far. Before I start hacking away I want to make sure that these pins do in fact work as a UART interface. I'm surprised this isn't defined clearly in the documentation because everything else seems quite thorough.
Hi,
As long as the pins are not used for anything else, you are free to configure them as UART. "This device provides flexibility when it comes to routing and configuration of the GPIO pins. However, some pins have recommendations for how the pin should be configured or what it should be used for."
infocenter.nordicsemi.com/.../pin.html
Regards
Runar
Hi,
As long as the pins are not used for anything else, you are free to configure them as UART. "This device provides flexibility when it comes to routing and configuration of the GPIO pins. However, some pins have recommendations for how the pin should be configured or what it should be used for."
infocenter.nordicsemi.com/.../pin.html
Regards
Runar
Thanks for your help, Runar.