The slm application for ncs2.3.0 has no log

I compiled the SLM application for NCS2.3.0 and burned them to the 9160 board.

I was given the following information. It seems to print only bootload-related logs, and nothing after that, and the serial port is still capable of sending and receiving commands.

I didn't make any changes to the application

Parents
  • Hi Harvey,

    You can change the SLM log level with the following configuration or simply modify it from Kconfig UI. Currently, it is set to INF by default, which means you can see the error, warning and info messages when they are available in the program.

    # CONFIG_SLM_LOG_LEVEL_OFF is not set
    # CONFIG_SLM_LOG_LEVEL_ERR is not set
    # CONFIG_SLM_LOG_LEVEL_WRN is not set
    CONFIG_SLM_LOG_LEVEL_INF=y
    # CONFIG_SLM_LOG_LEVEL_DBG is not set

    Best regards,

    Charlie

Reply
  • Hi Harvey,

    You can change the SLM log level with the following configuration or simply modify it from Kconfig UI. Currently, it is set to INF by default, which means you can see the error, warning and info messages when they are available in the program.

    # CONFIG_SLM_LOG_LEVEL_OFF is not set
    # CONFIG_SLM_LOG_LEVEL_ERR is not set
    # CONFIG_SLM_LOG_LEVEL_WRN is not set
    CONFIG_SLM_LOG_LEVEL_INF=y
    # CONFIG_SLM_LOG_LEVEL_DBG is not set

    Best regards,

    Charlie

Children
Related