Porting nRF51422 to Arduino environment

[Alex]

Hi all,

I would like to use the Arduino programming environment on my nRF51422 prototype. I have seen that RedBearLab has done the migration for the nRF51822 which quite similar. The source code is available here: github.com/.../nRF51822-Arduino Rfduino did also do it apparently: github.com/.../RFduino

Does someone have some experience on the this topic? I suppose that adapting the RedBear code to the nRF51422 should not be a problem. I am just not sure about the different modifications that I have to make.

Thank you

[Anders Strand]

You should not need to make any changes in the code between nRF51822 and nRF51422. Do you have a SWD debug interface on your prototype? I think rfDuino uses the uart interface to flash new firmware using a serial bootloader.