I noticed that my custom pcb draws power even when just commanding a simple system off call..
Im certain that this is not hardware related as I did the same with one of the nrf examples from SDK 15.3 and the power consumption goes down to below 100uA which I would expect.
Which preprocessor definitions or project configurations could lead to such behavior?
My main loop is just
NRF_POWER->SYSTEMOFF = 1;
nothing else so it must be in the configuration but I cant point out where. How would I find a source for this problem?
Im using an nrf52840 uC on a custom board but as I said hardware shouldn't be a problem as I tested this.