I am trying to test the nRF534 DK with my R&S CMW270 but i am not able to connect. i can see the Jlink ports but could not get a connection with either of them. I was able to program the DK to DTM mode using the nRF USB port but the CMW doesn't recognize it. It sees it as "Nordic Remote Shell sample."
Do you a driver i can use or different instructions to use the CMW?
Hi Jesse,
I checked with an expert regarding this.. It depends where the DTM UART pins have been set. Please do check the DTM plugin in nRF Connect first. It should be one if these:
Best Regards,
Swathy
Hi Jesse,
I checked with an expert regarding this.. It depends where the DTM UART pins have been set. Please do check the DTM plugin in nRF Connect first. It should be one if these:
Best Regards,
Swathy
i have tried both of these with no success. i have also tried directly to the UARTs with no success.
Is DTM only use with a MCU? I see both network and app so I don't know if i need to use a specific one because assigning the UART pots and connecting them doesn't work.
