Hi All!
I am using nrf21540 DK, NCS V2.3.0, and Vscode Studio.
An example I am using is the radio test. Build and loaded the code into the nrf21540 Dk. And Run the following commands on uart terminal
On RSSI Viewer (connected the nrf52833 DK)
VScde
I also monitored the SPI Signals on P1.13 ,1.14, and 1.15 but no signal during I was sending the commands as mentioned on the top.
my proj.conf file is
CONFIG_CONSOLE_HANDLER=y CONFIG_SHELL=y CONFIG_DYNAMIC_INTERRUPTS=y CONFIG_NRFX_TIMER0=y CONFIG_ENTROPY_GENERATOR=y CONFIG_MPSL=y CONFIG_MPSL_FEM=y CONFIG_MPSL_FEM_ONLY=y CONFIG_MPSL_FEM_NRF21540_GPIO_SPI=y CONFIG_MPSL_FEM_NRF21540_RX_GAIN_DB=0 CONFIG_MPSL_FEM_NRF21540_TX_GAIN_DB=20
Can you please help me in this regard where is the issue that I am getting a lower dbm value.
Thanks & Regards,
Muhammad Usman