Dear Nordic family,
I tried programming Raytac MDBT40 with the LED blinking code (taken from the example project of SDK 8) which worked with nRF51822 Bluetooth Low Energy BLE 4 and 2.4GHz Wireless Communication Module (purchased from exploreembedded).
Its getting programmed, but the LED is not blinking.
It there any extra software or hardware settings required for programming MDBT40?
Dear, Martin Børs-Lind,
I am using the same settings in Keil (PFA the screenshot)
Do you mean to say that J-Lite is required for working working with nRF go studio? I have connected it using J-Lite first and then tried clicking recover Then I get the following error as pop up.
Recover failed. Invalid operation error
Still no luck with LED blinking !!
Dear, Martin Børs-Lind,
I am using the same settings in Keil (PFA the screenshot)
Do you mean to say that J-Lite is required for working working with nRF go studio? I have connected it using J-Lite first and then tried clicking recover Then I get the following error as pop up.
Recover failed. Invalid operation error
Still no luck with LED blinking !!
