This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nrf 52 boot sequence

Hi,

I have a question regarding the NRF 52 boot sequence. When we first receive it from Nordic, what are the boot options? Are there any other options to load a code on top of using the debugger? The main issue here is how we should load the device in the manufacturing floor, what are the options?

Thanks Yaron

Parents
  • Hi

    Thank you for your question

    I can add a littlebit to syntroniks comment

    Some suggestions on the programming method are e.g. on this thread, update from 28.10.2015. It should identical identical nrfjprog commands for the nRF52 except: use "--program" when programming softdevice instead of "--programs". Make sure you have updated toolset for nRF52, as described in the migration document, section about "toolchain upgrades".

    Connections needed in order to program nRF51 are described on this thread.

Reply
  • Hi

    Thank you for your question

    I can add a littlebit to syntroniks comment

    Some suggestions on the programming method are e.g. on this thread, update from 28.10.2015. It should identical identical nrfjprog commands for the nRF52 except: use "--program" when programming softdevice instead of "--programs". Make sure you have updated toolset for nRF52, as described in the migration document, section about "toolchain upgrades".

    Connections needed in order to program nRF51 are described on this thread.

Children
No Data