This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nRF51822: Connecting VCC and AVDD?

Referring to the PCA10001 schematic, there is a solder bridge SB1, which connects AVDD with VCC_nRF.

Can you please explain in which cases is it needed?

Thank you Oleh

nrf51822_VCC_AVDD_SB1.png

Parents
  • Hi,

    For LDO operation: There's an internal coupling between VDD and AVDD, so that solder bridge does need to be shorted. However, the internal switch will add a series-resistance, so shorting SB1 it will lead to a lower resistance.

    For DCDC operation: Then there should not be a wired connection between AVDD and VDD, as AVDD will have another level than VDD.

    Best regards Håkon

  • Hi Håkon, it is good to hearing from you again.

    the reason for this question is: I've got few PCBs with DCDC configuration, but the solderbridge was defauls connected. Next PCBs are with int-LDO and low-energy configuration, so do not have this problem.

    But still wanted to ask if there was any damage caused to the chip in the case of DCDC... now I know :) I shouldnt try it :))

    Thank you also for explanation!

    With best regards Oleh

Reply
  • Hi Håkon, it is good to hearing from you again.

    the reason for this question is: I've got few PCBs with DCDC configuration, but the solderbridge was defauls connected. Next PCBs are with int-LDO and low-energy configuration, so do not have this problem.

    But still wanted to ask if there was any damage caused to the chip in the case of DCDC... now I know :) I shouldnt try it :))

    Thank you also for explanation!

    With best regards Oleh

Children
No Data
Related