Hello, I have looked into the compatibility matrix and I couldn't find any clear answer about if the NRF Beacon Kit is compatible or not with the S130. Does anyone tried to...
hi:
now.i have a development board(nrfgo motherboard).there is a debug port on the board.i think it can be debugged on the keil.if it can.what driver or others i need.thank...
This is what I got after upgrading my nRF51 dongle firmware.
It always times out.
I didn't somehow got one of my J-Link Lite upgraded, but couldn't repeat the process...
Hi all,
Good day.
Could you please recommend an Android or IOS APP which can connect 8 or more BLE peripherals at the same time.
Thanks & Regards
Jenson
I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Hi!
I'm having trouble getting any response from an NRF52840 MCU on a custom board we've made.
I'm hoping someone will be able to point me in the right direction by detailing...
I'm using pc-ble-driver(C program) to get the data from other device, I can get character now, but I don't know how to turn on the character's notification like the start...
We wanted to implement both BLE and serial DFU on nRF52832 without serial flow control. The main procedure is as follows:
Use the Nordic BLE DFU example as a start...
Hello,
I am using nRF52840, SDK_16.0.0, S140 SoftDevice and Segger 4.16 for flashing the image. I am using ‘ble_app_blinky’.
I have queries on enabling HW crpto accelerator...
I'm implementing the device side of the DFU-protocol (v16) (Control Point & Packet) using the nFR Connect Mobile as DFU Controller. In the app I select Application as file...
Hi All,
Since 2 weeks I try to configure a gap with a "raw payload" but it's a Chinese puzzle! Between different SDK, with different "Soft Devices" and examples dating back...
Hi,
I've install the throughput example (examples/ble_central_and_peripheral/experimental/ble_app_att_mtu_throughput) on an nRF52840-DK and I test it against all kind of...
I made 20 pieces of porototype devices. Testing some damaged them, NRF52832 does not work and the voltage on them is 1.556V, others work again but after disconnecting the...
Hello All,
I am trying to publish the data gathered from UART using MQTT . So far I was able to get serial data in the inData buffer. I am not able to publish data automatically...
To the kind attention of Nordic support team,
According to your valuable experience and manufacturers' capabilities, having the package a pitch of 0.35 mm is it possible...
I use nordic 52810.
I am trying to use s112 and HW IIC but I got the compiling error:
twi_hw_master.c:34:5: error: 'NRF_TWI1' undeclared (first use in this function) ...
I have a nRF52840 based product prototype which includes a power management integrated chip (PMIC) and a Li-Po battery.
The product recharges via a USB connector. The USB...
