Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
it register a handler, what about restart and run pstorage_register again, how it insure everytime we get the same address for our content in the flash?
before pstorage_register...
I'd like to measure the voltage of a lithium ion battery every minute or so in a way that's highly accurate. I need to do this without using the Soft Device because a) I need...
Hello,
We are wondering if the source code for nRFgo Studio is available? We mainly just want to look at the code for examples in creating our production flash programming...
nrf51_sdk_v5_2_0_39364\nrf51822\Board\pca10001\s110\experimental\ble_app_uart
And I just find this device as a bluetooth device but can not find any new uart device under...
Hi
I have bought nRF Beacon Kit, and I have downloaded "nRF Beacon Android 4.3.zip", but I can't find nRF Beacon Service source code.
Could anybody tell where it is...
Hello everybody,
I have a few questions about the built-in UART (UART0) in the nRF51822.
I've noticed some registers that aren't fully documented in nrf51.h of...
Hi,
I'm trying ti communicate two 18F26K22 Pics with NRF24L01. I wrote an library nrf24l01_ix4.h based on the nAN24-12 app note of Nordic. I don't use AutoACK and I set...
I can no longer step through code in the command line gdb client (nor the one in Eclipse CDT).
Eliots-MacBook-Pro:pure-gcc Eliot$ ./gdb_client.sh
GNU gdb (GNU Tools for...
Is it possible to buy the PCA10000, or a similar dongle that has an nRF51822 and a USB->serial chip (segger chip is not necessary as long as SWD connectors are exposed). ...
HI,all!
I was running the nRFToolbox app on Meizu MX3 phone (one kind of Chinese phones) with android 4.5, but the app was running out of control, so my question is:
1...
I love this part (the 51822) so far. Really. However, it really lacks in the debug support department.
Keil is a passable tool. Certainly not state of the art, but I can...
