I want to verify the 4Mbps transmission mode of the nRF54L15 series through ESB samples.But the highest value measured so far is 2.34Mbps, which is much lower than 4Mbps....
Hello,
I am currently using nordic connect sdk version v3.0.2 which seems to be the latest release on github. I am using https client example. As per the requirements...
Hi, nordic team
There is an issuse happened in my custom board with nrf52833,programming in ncs v2.9.0.
peripheral side is programmed base on peripheral_hid_keyboard and...
Hi all,
We are currently developing a modem application for use with a Linux host, based on a nRF9161 using nRF SDK 3.0.0 and toolcahin 3.0.1
When compiling the Serial...
Hi,
I'm using nRF SDK 16 for my application on the nRF52840 custome board. When I set both parameters (i.e., support for coded PHY and 1M PHY ) in the scan initialization...
Hi,
I made a custom board with nRF54L15. I do not have a spectrum analyzer, so I cannot tune how much power goes to the antenna or how much is radiated. So, I started ADV...
Hi,
I'm getting back "01 10 06" when attempting to send 0x01 Start DFU to the DFU Control Point from my gateway which is a Pi3 running Noble. Notifications are enabled....
Hello, i've read in the infocenter that there is/will be a new nRF52840-PDK Hardware (v0.11.x). Is it already available? If yes, who distributes it? If no, when will it be...
nRF52832 SDK 14.2
Hi.
I would like to know how I can run a function in the background? In my case, I want to process a queue in the background. Here is the scneario: ...
Hi all,
after call inside the BLE_GAP_EVT_LESC_DHKEY_REQUEST I got error 8, what can cause it? a CONNECTION_SUPERVISED_TIMEOUT?
device nRF52, SDK13
Thanks
Board: custom board; Mesh SDK: V1.0.0; Softdevice: S132_5.0.0; IDE: SEGGER Embedded; BLE: nrf52832
When I test the example “Interactive PyACI”, I need one node(A) send message...
I'm trying to connect with SPI interface. I've some little problems to understand about how technically do it,
I found this code on the web:
Just to understand how...
I want to monitorin some lockers situation. I thought if i use eddystone and ras pi i can monitoring locker lock or unlock situation. What ever how can i connect eddyston...
Hi, I recently purchased nrf52 development board for debugging nRF52832. I was following your tutorial "Development with GCC and Eclipse" and it is not working for me. Can...
For the Simple On/Off Model Light Switch Example.
If i am the client, and i got the handle of a specific server.
How can i query the Mesh Group Address that assigned...
Is there any way to get the currently used access address from the softdevice? I have an application that needs to know what access address is being used. I can sort of get...
