After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
Hi
my application is a 9-axis battery driven motion sensor with a data rate about 144 bit per packet at 1000Hz i have to transmit over air. Low latency (<10ms) is extremely...
Hi,
is there any Example to use the UART ?
I need an monitor while the application is running, is the UART COM Port the right one for this?
Is there an example with...
I need a mutex and I found this information at the ARM site: infocenter.arm.com/.../index.jsp
Is there anything I should be aware of in using this technique to implement...
I have a central device , that acting as a gatt server. the service is customize, and 128bit- primary serivice UUID ,its characteristics' UUIDs(128bit) are all known, how...
How are the four RAM banks divided up in the nRF51822? Is it an even split of the 16K total RAM (i.e. 4K per block)?
Furthermore, can I expect strange results if I turn...
Hello, sirs.
My question is how to configure clock in gazell protocol on nRF51822
I look at the example gzp_dynamic_pairing but that does not have a code part of modifying...
I want to stream data continuously from a sensor to a host, using BLE.
Using the nRF8001, I have defined a GATT server, with notification.
From an Android phone, I open...
Can the nRF51822 handle more than one connection at a time? I suspect that the answer 'no' based on some indicators, but it'd be good for me to get a conclusive answer. Thanks...
Hi,
i need to handle a button detection Time, i mean when i push the button for 2 seconds something should happen. How can i use the app_timer_cnt_diff_compute function...
Hi,
I have been experimenting with the master emulator .dll - I started with the HidDemo project which is written in C#. This seems to work perfectly well.
I have rewritten...
Dear Nordic Developer Zone,
I am working on a BLE application using nrf51822 with softDevice .
My aim is to be able to redefine which GPIOTE channel my PPI is using...
