Hi,
I have a serious problem, when I use uart of NRF51822 QFAAC0 to receive data from another MCU, I found that it will lost one bit at same position everytime. my SDK is...
Hi,
I just started to interface the lcd display with nrf51822 evaluation board. The display i'm using is, spi compatible, 18" tft (160x130) from tiny lcd. I took spi master...
Hi,
We are using the nRF905 device in an application where it needs to switch between auto-retransmitting and sending single packets, due to it communicating with several...
This is not a real question for support. It's more a success story i'd like to share with you!
Our company develops firmware for various customers on a lot of different...
Hi all,
What is the maximum data rate for the nRF24AP2 when using the Synchronous serial interface?
I cann't see it in the datasheet.
Is there anyone can answer me...
Hi,
In my design, there is a tag used by 24l01,It can transmit the temperature value.In the tag, the parameters are like this:
addrofch[0] = 0xe7;
addrofch[1] =...
Hello,
I have an nRF52 DK, running S132, as a client. After scanning and connecting, I use ble_db_discovery_start, which finds the devices of interest, connects, and finds...
As the title specifies, on writing to the registers mentioned, I receive a Fatal error.
Here's the test code
void save_ram()
{
__DSB();
NRF_POWER->RAM[0].POWERSET...
Hi,
I would like to know if anyone ever tried to alter the SEGGER J-Link OB Code that goes on the ATSAM3U2CA-AU IC (this is the IC that controls de PCA10040).
I'm asking...
Dear support,
I am working on some custom boards embedding the nRF52832-CIAA chip using SDK-v11.0 and s132-v2.0.1.
I have got 9 custom units and out of them only 4 work...
I asked about if NRF52 can pair to eachother without a PN532, but sounds like no, it can only read RFID tags.
So, how about if at factory we make RFID sticker/tag that...
Hi,
I need 32 bit timer-counter with s130 stack. Timer0 is 32 bits, but ble stack uses this timer. So how can i use timer1 or timer2 like 32 bit timer?
Is there any...
Do u have mobile/ios application that allows you to scan for Bluetooth low energy devices with nRF52840 and communicate with them?
If not, how we can do it?
Hi,
I am wondering which is the best method for BLE security to avoid MITM, protect the data (sniffers) and limit connection only to allowed devices for a massive number...
I am now using nrf51822 chip connected to a 50-ohm nominal input/conjugate match balun and then connected to an Embedded antenna.
I am requested to do a radio test which...
Hi,
In my project, I only have PCBs with nrf51822 chips and do not have a plan to buy a spectrum analyzer yet. But the certification requires me to apply DTM application...
The overall goal and then the specifics of what's been tried: I'm trying to utilize as much of the left-over flash space as possible to store environmental data during periods...
Hello,
I started working on mesh networking and to initiate i am looking at lighting control example . I have one nrf52dk PCA10040 which can be used as client and two nrf51...
I am working through link this tutorial and I've been able to successfully complete the steps up to D3. I'm using the bootloader_secure_ble example from SDK13 on an nRF52840...
RTT Viewer has been working great.
But is there a way to make the window buffer bigger so that I can scroll back more history?
It only saves about 80 lines.
Thanks
