Hello,In normal condition, I use UART,pwm,spi an so on.Now I want to clear the configuration, and enter System ON mode.But I don't want to system reset.
How should I do...
Hi, everyone~
My goal is to collect data from 4 sensors simultaneously using iPhone.
Now, my testing code for sensor nodes is working fine. It was built based on the...
I am an android developer and I am using your nRF Master Control Panel (BLE) product as published on Google play. Below is the link to the app:
play.google.com/.../details...
I want to build a USB dongle, so I purchased the nrf24lu1+ development kit. However, in order to program the target board, it would seem that I need the nrfgo. Is this correct...
Hi Nordic,
I would like to re/program my device using a OTA BLE Bootloader but i don't want others to copy my firmware or at least make it very hard. As far as i know there...
After modifying the ancs example to remove the data and control points, the event_connect() subfunction in ble_ancs_c.c gets called immediatly upon a connection to a master...
Hi Engineers!
We used SDK13 for our Project (multilink BLE with 1xServer & 4x PeerS) and now move to SDK14.2, almost done except only USBD.
if we use SDK13 driver...
I've already tried before using ADXL345 using nRF51822 using mbed compiler this is the link.. os.mbed.com/.../
but that program can't get ADXL345 data, just UART nRF51...
I'm trying to debug a project I recently migrated to eclipse but my Peripheral Registers are empty with the error message "There are no peripherals descriptions available...
I'm building a new application based on the no softdevice template example. I pulled in the code from the UART BLE example to redirect printf to the serial interface and that...
Seems i can not find where nrf_dfu_set_adv_name_init is defined? It seems not in SDK source files, neither can find any sign on SDK documents.
Thank you.
Hello,
I have a nRF52832 Breakout Board from SparkFun. I can see from their tutorial that I can program this board using the serial bootloader that they have burned into...
Hi everyone,
I make the project whith nrf51822 BLE module and need to configure the bluetooth service characteristic as input/output for reading and writing the string-information...
Product: nRF24Lu1+
If I use the nRFGo and the nRF24LU1+ Development kit, must I use the Keil tools to be able to access the debugging port? I develop in linux and use the...
Hi everyone,
My configuration:
nrf52832 microcontroller
Softdevice S132 V4.0.2
Nordic SDK 13.0
IDE: Eclipse
I'm working with a "Stand-alone can bus controller...
Hello All,
I am working nrf51DK and i am using ble_app_uart application with s130 softdevice.
Now my query is I am trying to send some data from my mobile application...
Hello Pros,
I maybe running the nRF52 close to its limit. It appears to have a probability of 1/1000 to 1/2000 to hit a 3004 in a continuous time-gated packets stream....
Hi,
I have created a custom service, and now I want to add different characteristics to it but with completely different uuids, not only the 12-13 octets.
This service...
Hello All,
I am working on nrf51dk , we are facing the issue if we send > 8 bytes of data in one time from Uart console then BLE_NUS will reset..
Our Setup:
ECU --...
