Hi all,
i want to establish connection between two threads in cmsis-rtos, can i use
1) semaphore to do this?
2)message queue should be used or any other ipcs can be...
Hi,
I have two CPU in our product. (STM32F2 and Nordic nrf51422).
I use serialization function to link those two CPU(refer to ble_s110_serialization sample)
But I find...
Hi,
My behavior is as follows
Turn on my device(use 51422) and advertising(2 Service and 3 Characteristic)
Turn on my cell phone(Samsung Note3),scan my device...
Hello:
I used analog IIC write MPU6050. Again after power download programs, mpu6050 can run up there ACK response. But the debug will not run. Simulation IIC because no...
Hello!
How can I communicate with my nRF24L01+ and nRF51822 at the same time. I can set up same channel, CRC-mode and I don't use ESB. But what about address? How do I set...
Hi all,
i want to know answer related to following question
1)what is use of uicr?
2)if i place some value in uicr and then change the image,then is there will be change...
It used to work, but now it says "Connected" but the rest of the GUI never changes and the mouse just shows a busy spinner. Here's the log file:
0;13:45:18.9900 [MainThread...
hi，dear.
I designed the hardware according to the datasheet of NRF52832, version 1.4, Page 545,Figure 169: QFAA and QFAB QFN48 with internal LDO setup.
In the picture...
Does anyone know of any current Apple devices (and a supported iOS version) that support extended advertising? I'd like to download the nRF Connect app on an Apple device...
SDK 15.3.0; nRF52832
In a previous discussion about continuing to advertise while connected:
[quote userid="4240" url="~/f/nordic-q-a/45644/how-do-i-simply-do-a-non-connectable...
Hi,
I've developed firmware for nRF52832 to beacon and scan for identical beacons. So with many devices, each can detect the others. What I've noticed is that while most...
Hi,
I am using the Zigbee CLI to maintain and control a Zigbee network. The Zigbee stack is running on a BMD340 module. I added a Ikea Trådfri dimmable light bulb (only...
Hello,
I'm developing a coin-sized board based on the nRF52840 and the nRF52833 in aQFN73 package. The PCB has only two layers with the bottom layer dedicated to ground...
I saw that in SDK there are examples with tcp, dhcp and etc of iot. If some router have usb port, is it possible somehow to configure nRF52840 as part of network infrastructure...
Hi All
I am using nRF9160 and read a value from Fuel Gauge IC (LC709203f) via I2C so I use i2c_scaneer sample
so I just a little bit confused what should I change in...
According to the nRF52832 spec, the flash memory can handle a minimum of 10K write/erase cycles. I need to understand the following:
I understand the write/erase cycles...
Hi team,
We are using Raytech nrf52840 dongles as NCP connected through USB to RaspPi compute module. We would like to upgrade the NCP application in the field using DFU...
Dear nordic,
I have an application that developed using development kit pca10056. I want to change it to supporting nRF52811. I want to test the long-range feature of nrf...
Hello. I'm a CS student and I've bought myself two NRF52840 Dongles. I've downloaded NRF Zigbee SDK and wanted to flash and try out some examples. But the simplest light_control...
