I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Hi,
Our Application software running in Micro is communicating with BLE over UART.
So in nutshell, we are using serialization to speak with soft device present on NRF52810...
Hi,
I'd like to have a second UART available, as the nRF51822 only has one and I'm wondering if there exists a UART software emulation example implemented already for this...
Hi!
I'm trying to add logging modules to my own libraries that I've created. I'm using SDK 14.3 with the nrf52832. I can enable logging for any of the SDK driver/libraries...
I am using nRF Connect to measure the power of the nRF52840 DK. But I don't know how to output the raw data out. Is there a way that we could get the data out from nRF connect...
We are evaluating to use this IC for BLE/NFC purpose.
we would like to flash the nRF52840 thru our Linux processor (not using external flashers), using the SWD lines connected...
I am using nRF52 DK and program example code ble_app_beacon and test with nRF Beacon APP, we are not able to connect to update UUID , Major and Minor values , however beacon...
Hi!
I use SD 6.0.0 and SDK 15.0.
I am developing an application and I want it to include service of buttonless OTA firmware updating. So far I have managed to zip my application...
i init the saadc and uinit saadc ,then init saadc again. my code is below:
err_code = nrf_drv_saadc_init(NULL, saadc_callback); err_code = nrf_drv_saadc_channel_init(0,...
Dear Sir,
I have connected a phone to a peripheral device using NRFconnect App.
Now I want to know the rssi value of the phone on the peripheral side.
I want to get...
I have an application with a custom service, based on the ble_app_template example. I want to add DFU functionality. I flashed the DFU secure bootloader and can discover the...
If I use NRF_SDH_DISPATCH_MODEL with NRF_SDH_DISPATCH_MODEL_APPSH what size do I need to use for the scheduler data size and queue length in
APP_SCHED_INIT( ?, ? ),
Is...
