Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello, I have a question.
The chip uses nRF 52832. MDK keil μVision V 5.22.0.0 is used as the development environment.
I am using nRF5_SDK_13.0.0-1.alpha_055eef3.
It...
Since September I get multiple warning messages on projects that use both the nRF51822 library and the mbed library. This is even true for example projects for the 51DK board...
Hi,
I put my nrf51 into power-on sleep mode by calling sd_app_evt_wait().
When I walk away with my mobile phone, the bluetooth disconnected and my nrf51 can receive...
Hi there,
I am currently working on a custom GATT profile for constant data streaming. I have to keep to GATT because I need multiple attributes to keep track of different...
Hi
I saw the Central and Peripheral example code has peer_manager in sdk 12.2 and BONDING_ENABLE in sdk10.
What are they does and where has document I can read.
If I...
From the Nordic errata [141] on NFCT not stopping HFO when going from activated state to sense state:
Workaround:
Power cycle the NFCT using the POWER register, then issue...
Hello.
EDIT: When I connect to nRF52832, Windows are not creating bluetooth serial com port. And Bluetoth Services are not getting.
How Can I do this??
Thanks.
Hi.
Is it possible for the NRF52840 to act as a USB host? or is it "only" a USB slave?
It would be awesome if we could connect a usb peripheral directly to the NRF52840...
I'm confused.
in other platform, i know flash stard and end adress ,alse page size ,i can read and write data directly.
But use pstorage mode as follows :
pstorage_init...
Hello,
I want to bring some data by UUID.
I know the ble_nus_init() can set UUID and I know it was set by sd_ble_uuid_vs_add().
But this way only change the UUID while...
Hello.
I loaded Soft Device and UART example on the board. Then I connected Nordic_UART through by Bluetooth.
And I want to add a virtual COM PORT on Win10. I entered...
I want to connect the nrf52 board to my nanoPI via cables/connectors, making a serial communication,
is there an example/tutorial for that?
It's worth mentioning that...
