Hi There,
I am using a nRF52840DK board to experiment with NFC Tag technology.
I started with the "Writable_ndef" example inside the nRFConnect, and it works.
I wrote...
Where can I obtain the security certificates (e.g., client certificate/private key) needed for TLS authentication with nRF Cloud? - Are these generated during device onboarding...
I plan to use my own SIM card (not from Ibasis). Could you clarify how to register the device in nRF Cloud to enable A-GPS services? - Should I link the device’s IMEI or ICCID...
Hello, I am developing nRF5340, the project is pre-production. I am getting a issue with BLE power consumption, when I turned BLE on, the current is about 9uA. with BLE beacon...
Hi ,
1.In the example: In nRF5_SDK_17.1.0_ddde560_usbd_msc_1\components\libraries\block_dev\qspi\nrf_block_dev_qspi.c, I need to set the following 0xB7 bytes. How should...
HI ALL,
nrf54l15dk,v2.8.0,peripheral_uart demo and no changes have been made.
Then add the following content to prj.conf
sysbuild.conf
mcuboot.conf
At this...
Hello!
I'm currently working with the nRF7002 Wi-Fi chip on a custom board. The MCU used is STM32H573ZIT6, and the software is Zephyr 4.0, specifically using the Wi-Fi shell...
There have been a couple of questions asked that are similar to my question but in the interest of getting more clarity I am asking a new one as others have had accepted answers...
So, I open a nRF51 project today and found out that it failed to build. Turns out my uVision lost all of the target devices in its list, leaving only STM32 F0 and L0 series...
I am trying to download the examples from NordicSemiconductor/nrf51-ble-tutorial-advertising
The link shows:
github.com/.../main.c
but when I click on it, or right-click...
hello,
i am uing nrf51822.now i am in trouble while running uart on nrf51822.please tell me which can i have to burn on nrf51822 for getting uart properly working.i am using...
Hi,
Is there any information on how much improvement the DCDC has over the LDO at 1.8V? I'm working on a heavily space-constrained application, and I'm trying to make a decision...
Hi, i am working on PWM Library example in which i a m configuared GPIO pin P0.25. then i am getting voltage variations 1.3 to 2.8 volts.
the problem is when i disable...
Hi,
I want to connect old nokia 3310 to NRF52 DK.
Please let me know if any one has information about it?
Based on my research old nokia phone uses M bus and F bus...
Hi,
We're working with very specific hardware which requires us to watch very closely. We're currently considering a blocking function in an ble event handler which can...
Hi all,
We are currently developing a BLE enabled sensor device. We want to use the NFC component to identify the sensor by writing a device ID to the tag.
Question...
Hi,
The comparator (COMP) in nRF52 can use three internal reference voltages (1.2, 1.8 and 2.4V). Is it possible to also output these voltages on IOs?
Best regards
...
hello there in my code,
APP_ADV_INTERVAL 64
APP_ADV_TIMEOUT_IN_SECONDS 5
using nrfsniffer i am getting 57 packets in 1 second.
i can't understand it. because APP_ADV_INTERVAL...
Hi!
I tried to some research in the forum but I would like you to assert my final decision.
My goal is to design a sensors network (at the beginning with five end-nodes...
