Hi,
While testing the device firmware update through the nRFtoolbox android application, i get "device has no required service" error more frequently.
I use latest version...
I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
I am getting get BLE_EVT_USER_MEM_REQUEST and BLE_GAP_EVT_CONN_PARAM_UPDATE event, when writing to ble device, sample code did not handle these event, and seems no document...
Hello:
Why do I erase SDK5.2 version of flash and read not, in SDK4.2 can. I tested nrf51_sdk_v5_2_0_39364\nrf51822\Board\nrf6310\flashwrite_example is a good example.However...
Hello,
I need to transfer a lot of data over USB. I configured the USB as a USB_CDC_ACM on the nrf52840.
Everything works but the problem that i'm running into is that...
Hi there,
I'm currently using micro-ecc on an nRF52 compiled using Nordic's makefiles and implementing the secp256r1 curve. I'm mirroring this in Node.js using the Crypto...
Hey,
Can the nRF52 support 'Thread' / '6LoWPAN' protocols in the future?
Can the component support it (PHY wise etc) with the right 'softDevice' stack drivers?
Thanks...
I have used nrfgo studio, nrfjprog, jlink commander. Whenever i try, it is unable to find the jlinkarm.dll. i have checked the registry, reinstalled everything, but same error...
I use example ble_app_uart_pca10028_s130, I want to change the connection parameters by changing #define MIN_CONN_INTERVAL, #define MAX_CONN_INTERVAL, but when I use oscilloscope...
Hi,
I have been using the nRF51-DK to develop a program for capacitive sensing. I want to design a custom PCB with the nRF51422 chip on it. Do I need to have an oscillator...
Hello,
Using NRF52832, I need to convert to BLE 19.2 kbits / sec bit stream, received from another processor UART. I need a sample program, which I can adapt to do this....
Hi I was use example ble_app_uart with SDK 12.3.0 and nrf51802 for a data transport, after BLE connection, the example need uart receive more than 20 or "\r\n" ,the data will...
Hi, for carrier and modulation carrier signal is confusing.
What is the difference between their center frequency point for same frequency? Or modulated carrier will...
