Hi,
I was looking at the .map for my project and I noticed that pstorage.c was taking up a bunch of RAM (~600 bytes), which I thought was a lot, so I went into pstrorage_platform...
The document nRF51422_Evaluation_Kit_User_Guide_v2.0.pdf says:
Locate the Heart Rate demo project found in the folder
ARM\Device\Nordic\nrf51422\Board\pca10003\s310\ble_app_hrs...
Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Using the nRF Beacons app, but cannot see the battery condition of each beacon. Is this already implemented - if so how to turn on? If not how is it implemented?
Hi All
I am doing a BLE based project using nRF51822.Where i need to handle the message [with UUID] by using ble_gatts_char_handles_t.
so, can any one please share information...
I have a central application and peripheral application that are based on the multilink-central/multilink-peripheral examples.
I've modified them to run on the PCA10001...
Hi All,
I'm using nRF24L01P for TX device and want to receive packet from nRF51822 RX device.
nRF24L01P TX device Register settings are as follows;
Reg.EN_AA=0x00...
Hi
I'm currently working on the 10028 DK board, which was working flawlessly until I used the J-link RTT Viewer, and pushed the IF BOOT/RESET-button. Now, when I try to...
Hey,
SHORT VERSION:
Timer (every Second) gets started when connecting (BLE with nRF Connect) to my DK (SDK12.2, Softdevice S132). Timer gets stopped when disconnecting...
Hi There,
We have an issue where our project crashes, but the app_error_fault_handler() callback is not being called to help identify the cause of the issue. We are using...
Hello guys.
I'm newbie to embedded programming.
I'm trying to make device that can measure temperature of other objects. I have a variable resistor. The resistor's resistance...
My BLE application uses my own firmware update algorithm and bootloader, as well as the Peer Manager module. To ensure that I do not delete peer data during the update process...
I am using nrf51 running as a peripheral and an iphone app as central. It works OK when I first use the iphone app to connect to nrf51. Then I quit the iphone app and let...
Application data is stored just before the bootloader. If I do a DFU upgrade with a larger bootloader than the one currently flashed, is this taken care of? That is, is the...
i am using keil mdk5 and i want to use nrf51822.please tell me which software i need for this and which sdk i have to download for this.i am currently troubling with doing...
I'm facing problem while program custom board. I'm using nrf51822 module( link ) & j-link EDU 9.3 version. I think there is some connection issue. Here is my connection
...
Is there any reason why no error is returned when app_fifo_get() fails in app_uart_put() (SDK 12.0.0). Couldn't the lines below:
if (app_fifo_get(&m_tx_fifo, tx_buffer...
Hello,
I'm facing some problems when trying to migrate from secure dfu debug to release mode.
I set the nrf_log to use uart instead of rtt in both debug and release...
Hello.
We are building our project based on nRF52 chip and BLE beacon firmware. Do you know if we need to buy some MAC address range from "provider" or we can code some...
