Hello. I am literally looking at the set_hrm_cccd function in Python used to write data. This is for the S130 heart rate collector example. I understand the sd.ble_gattc_write...
Totally new to Python but managed to get things like pyserial setup and I've been able run the ble sniffer. However that is as far as my Python knowledge extends, so I need...
pstorage_load and pstorage_clear appear to work fine, but whenever I do a pstorage_store the callback function is never called. This happens whether or not the Bluetooth unit...
Our USB keyboard using nrf24lu1p does not work on Mac OS 10.11.
Before Mac OS 10.11, USB keyboard was worked, but on Mac OS 10.11, it does not work.
I think your library...
In my design I need the RX to be standalone , I.E. no controller attached to it , does the programming STORE in the Chip ? If I set it up as a RX and set a specific Ch. Freq...
[Dev Env]
nRF51 DK
IoT SDK 0.8
IoT SoftDevice
[Question]
how i change my ip in ipv6_coap_server example use ipv6_address_set / ipv6_address_remove API.
To...
Hi Guys,
I have a MCU RTOS project. in Hardware board, builtin Nodic BLE chip over UART,RTOS BLE stack works fine.
We also have a MCU RTOS Emulator based on Qemu,we...
Hi
Does the newly released nRF52840 chip have pins on the side, corresponding to the "outer ring" (A8-23, AD2-23, B1-W1, ...) pins on the underside of the chip, like this...
hello i am interfacing i2c sensor mma8452 with nrf51 dk. my function is
void mma_read(uint8_t *x, uint8_t *y, uint8_t *z)
{
uint32_t err_code;
uint8_t rx_buffer...
I have to sample 3 differential channels periodically. Should I calibrate SAADC for each channel individually? Unfortunately, "nRF52832 - Product Specification v1.0" doesn...
Update 2016-Mar-29: I used SDK v10 along with SoftDevice S110 v8 when I run the experiments described in this question.
Update 2016-Mar-30: Upload source code of the modified...
In order to perform dfu to softdevice S132 v3 sdk12 (secure bootloader) from sdk11 softdevice S132 v2 (legacy bootloader).I've change the legacy bootloader as it it says here...
by using Arduino mini pro 3.3v
I am planing to measure the temperature for the first five minutes, if the temp is over 40 degrees the device will send to Android app and...
Even though the SIG hasn't finalized yet and the 1.4.0 SoftDevice isn't out... Can we get a heads up on what to expect for 1.3.0 BLE 4.2 compatibility?
On something...
In arm_startup_nrf52.s (in the 8.9.0 device family pack), there is a new bit of code:
IF :DEF: __STARTUP_CONFIG
#include "startup_config.h"
ENDIF
I assume this...
Hi,
I'm thinking of using the NRF52 for an embedded wearable sensor application.
How much flash and Ram space can I expect to have remaining approx. for my application...
I'm a bit at a loss of how to voluntarily stop advertising: My related thread says I should call sd_ble_gap_adv_stop() , but when I do, no corresponding event is raised by...
To install micro-ecc, complete the following steps:
Install version 4.9-2015-q3-update of the GCC compiler toolchain for ARM. You can use ARM's Launchpad to find the toolchain...
