Hi,
Developmente setup: Windows x64, nrf connect for vs code, SDK and toolchain versions 3.0.2.
I was trying to build a proyect for a custom nRF5340 board when I encountered...
Hi,
I recently found out about the Periodic interval feature on GRTC CC[0] and it seems like it would be quite useful for my application. Most of my code so far uses the...
Hi,
I have integrated Neuton’s “Transport Type Detection” pre-trained model into my firmware, running on a nRF52840dk. For collecting 9-axis IMU data, I’m using the ST X...
I'm trying to implement a fall detection feature on the headset side using the LSM6DSOX IMU sensor. The IMU is configured successfully, but the board halts after the INT1...
I have a ready hogp struct and I'm trying to subscribe to an input notification (I'm connecting to a bluetooth keyboard) and I'm getting error -22. Here's the callback in...
Hello Nordic Team
I am using SDK 3.0.1 with a nRF52DK to develop a firmware that can be switched from BLE mode to GAZELL mode and vice versa over a command sent via UART...
Hello,
I am designing a custom PCBA based on the nRF7002DK PCBA and I really need the Fabrication Notes / Drawing that officially went to the fabricator to direct the build...
Hi,
I am using nrf52832 for my application. The application share same SPI module for two sensors(with sensors are selected using two chip select pins). Is it possible...
Hello ,
following are my requirements :
to create a secure bootloader which checks app validity at every boot .
the boot loader should also accept UART communication...
I have an Eddystone beacon from minewtech...i've downloaded the nRF connect app onto my android tablet and i can connect to the beacon. the problem is that it's not "taking...
On the nRF51822 Is it possible to check the battery level using the on-board AD, software connected internally, avoiding external resistor divider.
If not what is the best...
Hello,
I've been trying to migrate a project from the nrf51822 that uses s110 7.1.0 softdevice to the nrf52832 s132 1.0.0.3 alpha softdevice. I had to change some given...
How can I found out my NRF51's device Address? (with Softdevice using Random static address?)
Does Softdevice has any API for fetching my device's BLE Address?
As I...
I'm looking at the sequence diagrams for the secure bootloader, and I'm confused about the response procedure opcode for Packet Receipt Notifications (PRN). From the diagram...
Hi
for a new project I need to combine bluetooth with 2G/4G cellular communication, and augmented positioning, meaning we want to use cell tower, GPS and scanning of Wifi...
hai
i want to store a struct contains two elements . can i store it in flash using pstorage....?
if so how can i do that.........?
or
can i store a two dimensional...
I want at s132 use RT-Thread RTOS,but I see arm_startup_nrf52.s file defined Stack_Size and Heap_Size 8K, can define Heap_Size = 0? reduce the Stack_Size (such as 4K)?
so...
Hi,
I want to know that what is the different between RS232 and TTL.
I want to know that can we two RS232 to TTL converters back to back in the wire ??
Hi,
I'm using nRF52832 Software Development Kit, PCA10040, S132.
In nRFgo Studio, I erased all my SDK.
In nRFConnect, I selected serial port which SDK connected.
And...
