We are developing a light product that features a built-in button. A single click of this button toggles the light on/off, while a long press adjusts the brightness level...
Hello!
I have tried in various ways to make the XIP part functional on SDK version 3.0 (SDK v3.0.0-3bfc46578e42) but without success, this on the NRF5340 devkit. I mention...
Hi We are working on setting up CI/CD pipelines for our nRF application. The application is set up as a stand-alone application with its own west workspace. It uses external...
Hi ,
1.In the example: In nRF5_SDK_17.1.0_ddde560_usbd_msc_1\components\libraries\block_dev\qspi\nrf_block_dev_qspi.c, I need to set the following 0xB7 bytes. How should...
Hi I'm testing the current consumption of the external qspi-flash on nrf5340dk [ MX25R6435F]. I have used ppk 2 to measure consumption with the dk and also have used a power...
Hi,
We are using nrf21540 in GPIO mode + mode pin ( and CONFIG_MPSL_FEM_NRF21540_RUNTIME_PA_GAIN_CONTROL) with an nrf52833.
We are developing under nrf connect sdk 3.0...
During the development of a Matter over Thread product, I encountered the following issue:
After adding two Matter over Thread devices (an OnOff Switch and an OnOff Light...
Hi,
I am using nrf_gpio_port_read to read port 1 (pins 8-15), and I want to know how long it takes to read the port, ie. how many instructions. I am doing this in an interrupt...
I have a need to maintain current state of my device along with other parameters, including temperature and hours used. If I update my pstorage page frequently, like once...
Hello,
I'm working on S110 peripherial <-> S120 central project using GATT. I have succesfully implemented S110-based peripherial device with some custom characteristics...
Hey All,
I am trying to create a simple data transfer system using a DFRobot Bluno (CC2540 chip) as the central device, and a Redbear Labs Blend (nRF8001 chip) as the peripheral...
Hello all,
In many thread I can read that it is not recommended to use the internal DC-DC converter to supply the nRF51822.
Can you tell me why it is better to use an...
Greetings all -
We have an nrf51-dongle for development and testing purposes, and are unable to connect to the device over USB with any of the Segger or Nordic tools. I...
Due to BLE's low range, license costs and unneeded complexity, I am looking in to pure radio RF. I am curious about ESB and Gazelle, and which one is good for relatively simple...
Testing OTA using nRF Toolbox on Android. Everything works fine, but for some reason the file selection is "stuck" in dropbox, i.e. I can not go up a level from dropbox, and...
my development environment is nRF-DK and IOT SDK
Q1 : IOT SDK Support Gatt Profile?
Q2 : IoT SDK Support DFU mode?
Q3 : in ipv6 coap server example, how i broadcast...
Hi!
I have custom board with nRF51822 and I need to communicate with serial flash W25X40 using SPI master example with SoftDevice enabled (S110 is used). I worked with...
Hello Everyone
i am using LINK LOSS service i would like to send notifcation to the peer device if the connection is lost and also if the connection is made between two...
